Рефераты Acoustic emission (Акустическая эмиссия)

Вернуться в Иностранные языки

Acoustic emission (Акустическая эмиссия)
Moscow State Technical University named after Bauman



Essay


Acoustic Emission



Post-graduate Golenkov N.S.
English Teacher Kislova V.M.



Moscow
2001
The appearance of new technologies as well as the perfection of traditional
ones is mostly based on the results of research in the fields of solid
physics, quantum mechanics, physical chemistry and other fundamental
disciplines. That is why perspective methods of technological diagnostic
must have an advanced trend of development comparing to the development of
new structure and shape forming methods.

Intensification of science research in the fields of emission methods
analysis reflects the above-mentioned matters. Emission diagnostics methods
are based on the effect of radiation of elastic deformation waves,
electrons and electromagnetic waves by studied object. Object condition is
identified registration and analysis of radiation parameters based on the
condition change can be made. The above methods represent so called inner
energy methods and have a number of advantages allied with anomalies of
material structure.

Amongst diagnostic methods the most widely spread in field of machinery
construction is an acoustic emission method based on generation of elastic
deformation waves in solid body caused by defect development, phase
transformation and other elapsing processes. Analysis of all parameters
allows to make judgement, regarding damage dynamics of material. It is used
effectively for undamaging control while testing and using articles.

It is necessary to mention that an acoustic emission method is one of the
newest and most prospective diagnostic methods. It is physical nature
causes expanding fields of application for the method in technology.

First works by acoustic emission method appeared in 70s. This works
fulfilled in the late 70s and early 80s are characterized by fairly narrow
range of technological tasks, connected mostly with tool wear control.

Sources of an acoustic emission are divided into internal and external.
First ones are sources located on object’s surface. For example, acoustic
emission caused by friction, blow, turbulent fluid and gas streams.
Processes of local dynamic redistribution of tension fields in material
apply to internal sources of acoustic emission. For example, acts of
plastic deformation, micro- and macro destruction and phase transformation.
Analyzing the cut zone from these positions can make a conclusion about
existence in this zone whole number of acoustic emission sources of
different power and spectral density. Acoustic emission parameters depend
on a way plastic deformation, destruction and friction processes go. It is
possible to carry out acoustic emission diagnostic. Beside, frequency range
of registration of acoustic emission parameters usually estimates in tens,
hundreds and thousands kilohertz and is well protected from noises, which
accompany work of technological equipment units.

In many aspects the acoustic emission method reminds those of low-frequency
acoustic spectrometry, although in other aspects it is completely
different. Acoustic emission methods are a clear shown wave process
accompanied by variable space-time localization of elastic energy.

The increase of mechanical processing efficiency is tied with search and
realization of new speeding-up methods of technological preparation for
shape forming processes. Methods of rational carving conditions
determination are being developed as one of the most important tendencies
in practical use of emissive technological diagnostic means.
An important direction in the practical use of progressive technology
diagnostic methods for carving process is the quality analysis of surface
detail layer during the processing
Добавить в Одноклассники    

 

Rambler's Top100